The Glowforge for the van is on a high density plastic utility cart.
A couple of the legs cracked and I fixed them with some flat iron.
One of the bolts gets in the way of the dryer vent exhaust and it has been ripping it.
So I decided to create an exhaust flange/adapter to get past the bolt. At the bolt, the opening is diminished by about 10 mm in diameter (the center part of the adapter). I forgot to make this center part have 64 sides, so it has the default 20. But that works out okay. It took 2 hours 40 minutes to print on Ultimaker at 0.25 resolution.
It fits on the glow forge fine and a hose clamp fits on the other end.
Leave a Reply